ПОТОЛОК+
05/ 09 services
Electrician services

Socket and switch replacement in Tashkent

We remove the old mechanism, inspect the conductors and install a new socket or switch. If a contact is burnt or the circuit is weak, we show the issue before covering it with a new frame.

Socket and switch replacement
Socket and switch replacement
9services
18areas
Mon–Satby appointment
✓test after installation
01Service scope

What the work includes

We inspect, install and show the final result.

What the work includes

  • Circuit isolation and old mechanism removal
  • Wire inspection and preparation
  • New mechanism and frame installation
  • Functional test under load

About the work

Replacement is needed when a plug falls out, a rocker sticks, the body heats up or scorch marks appear. We isolate the circuit and inspect both the faceplate and wire contact.

We install single and grouped frames, standard and two-way switches. The new mechanism must suit the back box and the condition of the circuit.

Cost depends on point count, mechanism and wire condition. Moving a point or adding a circuit is separate work after route inspection.

02Key details

Socket and switch replacement

Mechanism, frame and contact replacement when a point is loose, sparking or not working

01

Conductors and contacts checked, not just the frame

02

Single, double and grouped mechanisms

03

Standard, two-way switches and dimmers

04

Operation and heat checked after replacement

Where it is used

ApartmentOfficeKitchenBathroom

Replacing one point does not renew old wiring. If the whole circuit heats up or many new sockets are needed, choose wiring installation.

03How it works

From task to test — 4 steps

Scope and cost are agreed before installation, not after switch-on.

01

Task

Describe the issue or send photos of the point, appliance and installation area.

02

Inspection

We check the base, outlet, circuit and protection relevant to the job.

03

Agreement

Scope is confirmed before work starts, with any extras listed separately.

04

Installation

We isolate power, complete the work and test the result after switch-on.

05Questions

What customers usually ask

Short answers about installation, limits and quoting.

01Can you replace only the frame?
Yes, if the mechanism and contact are sound. Heat, scorching or looseness means the internal part should be checked first.
02Can you move a socket?
Yes, but that creates a new route and point. Scope depends on the wall and cable-installation method.
03What should I do if a socket gets hot?
Disconnect the load and stop using it until inspection. The cause may be a loose contact, mechanism or circuit.
06Areas

Socket and switch replacement: Visits across Tashkent and the region

Select an area — service tabs keep the chosen location.