Light-fixture installation in Chirchiq
We lay out and install indoor spots, surface fittings and pendants. On stretch ceilings we work through a mounting platform and thermal ring, with no load or excess heat on the film.
A separate city with older flats, new housing and private homes
What the work includes
We inspect, install and show the final result.
What the work includes
- Lighting-point layout
- Installation on prepared platforms or bases
- Connection and fitting placement
- Test of every point after installation
About the work
Fixtures provide even or zoned room lighting. We account for furniture, work areas and existing outlets so a point does not end up above a cabinet or behind a door.
On a stretch ceiling the fixture sits on a platform. We use a suitable gap and LED source; high-heat lamps are not installed close to PVC film.
Cost is based on point count, fitting type and wiring readiness. New outlets are agreed and quoted separately before work starts.
Light-fixture installation
Recessed, surface and pendant lights — including stretch ceilings
Points planned around furniture and room use
Platform and thermal ring for stretch ceilings
Low-heat LED with a safe film clearance
Every point and switch tested
Where it is used
This service covers indoor spots and ceiling fittings. Chandeliers, wall sconces and outdoor floodlights have their own pages.
From task to test — 4 steps
Scope and cost are agreed before installation, not after switch-on.
Task
Describe the issue or send photos of the point, appliance and installation area.
Inspection
We check the base, outlet, circuit and protection relevant to the job.
Agreement
Scope is confirmed before work starts, with any extras listed separately.
Installation
We isolate power, complete the work and test the result after switch-on.
Chirchiq
A separate city with older flats, new housing and private homes
In Chirchiq the starting condition of the network depends strongly on the property type. For repairs we first locate the panel and identify which part lost power; for new work we establish what is already prepared.
- 1Points planned around furniture and room use
- 2Replacing one breaker does not solve an overload when the cause is in the circuit or connected appliance.
- 3Panel and problem-point photos help before the visit, especially when only part of a room has lost power.
- 4Platform and thermal ring for stretch ceilings
What customers usually ask
Short answers about installation, limits and quoting.
01Can a new light be added after the ceiling is stretched?
02Which lamps suit a stretch ceiling?
03Can you wire new lighting points?
Light-fixture installation: Visits across Tashkent and the region
Select an area — service tabs keep the chosen location.